Search in Brand
Filter Your Search
Shop by Category
Search Results
ABRITES AVDI CHRYSLER SAE J1580 ADAPTER-J1850
The J1850 Adapter will allow special functions operation with SAE J1850- based diagnostic protocols used in the past from Chrysler, Dodge, Jeep, Plymouth, Ford, etc. J1850 is primarily used for key programming among other functions.
ABRITES AVDI ABPROG MERCEDES BENZ NEC ADAPTER WITH SOCKET-ZN032
The ZN032 adapter is used for reading, writing and erasing of NEC MCUs from Mercedes-Benz IR-keys without soldering the memory to the adapter.
ABRITES AVDI VAG MICRONAS CLUSTER ADAPTER-ZN060
This adapter is used to enter service mode for VAG VDO dashboards with a Micronas processor, the new style connector and TP2.0 protocol.
ABRITES AVDI VAG VDO (NEW STYLE) MICRONAS CLUSTER ADAPTER-ZN059
This adapter is used to enter service mode for VAG VDO dashboards with a NEC processor and using the UDS protocol.
ABRITES AVDI MERCEDES BENZ IR KEY 315 MHZ FOR USE WITH PROTAG-TA15
TA15 is a KEY for all types of Mercedes-Benz vehicles with IR. The working frequency of the key is 315 Mhz. It can only be programmed using the Abrites ZN002 PROTAG programmer. These keys can both start the car and function as remote controls.
ABRITES AVDI MERCEDES BENZ IR PCB 315 MHZ FOR USE WITH PROTAG-TA15
The TA21 is a PCB that fits Mercedes-Benz chrome key shells. The frequency of the key is 315 Mhz. It can be only programmed using the Abrites ZN002 PROTAG programmer. These keys can both start the car and function as remote controls.
ABRITES AVDI TOYOTA BLADED H (ZN067, ZN068) ADAPTER SET-ZN069
The ZN069 set is a set of adapters required for key programming of H-type mechanical keys (DST-AES)
ABRITES AVDI JAGUAR AND LAND ROVER ALL-KEYS-LOST CABLE SET-CB012
This cable set for direct CAN-BUS connection is a proprietary hardware, designed, developed and produced by ABRITES. It is a universal solution when direct connection to the CAN-BUS network is required. The CB012 needs to be connected between the AVDI and the OBDII cable.
ABRITES AVDI TESLA MODEL S/X CABLE SET FOR USE WITH TS001-ZN072
The ZN087 is a cable set designed, developed and produced by Abrites for working with Tesla vehicles. This set contains two diagnostic cables; one for the Tesla Model X/S (the ZN071 cable) and one for the Model 3 (the CB027 cable).
ABRITES AVDI NISSAN/RENAULT INTERNAL CAN CNNECTION JUMPER CABLE-CB021
The CB021 jumper cable is used for internal CAN connection when performing key learning procedures on Renault and Nissan vehicles. It is also applicable for mileage re calibration and module replacement in a selection of Renault models.